Three resistors having resistances \(r_1, r_2~\text{and}~r_3\) are connected as shown in the given circuit. The ratio \(\frac{i_3}{i_1}\) of currents in terms of resistances used in the circuit is:

  
1. \(\frac{r_1}{r_1+r_2}\)
2. \(\frac{r_2}{r_1+r_3}\)
3. \(\frac{r_1}{r_2+r_3}\)
4. \(\frac{r_2}{r_2+r_3}\)

For the circuit given below, Kirchhoff's loop rule for the loop \(BCDEB\) is given by the equation:

In the circuits shown below, the readings of the voltmeters and the ammeters will be:

The reading of an ideal voltmeter in the circuit shown is:

The potential difference \(V_\mathrm{A}-V_\mathrm{B}\) between the points \(\mathrm{A}\) and \(\mathrm{B}\) in the given figure is:
    

\(\mathrm{A, B}~\text{and}~\mathrm{C}\) are voltmeters of resistance \(R\), \(1.5R\) and \(3R\) respectively as shown in the figure above. When some potential difference is applied between \(\mathrm{X}\) and \(\mathrm{Y}\), the voltmeter readings are \({V}_\mathrm{A}\), \({V}_\mathrm{B}\) and \({V}_\mathrm{C}\) respectively. Then:

       

In the circuit shown cells, \(A\) and \(B\) have negligible resistance. For \(V_A =12 ~\text{V}\), \(R_1 = 500 ~\Omega \), and $\mathrm{}$\(R = 100 ~\Omega \) the galvanometer \((\text{G}) \) shows no deflection. The value of \(V_B\) is: 
     

1. \(4\) V
2. \(2\) V
3. \(12\) V
4. \(6\) V

In the circuit shown in the figure below, if the potential at point \(A\) is taken to be zero, the potential at point \(B\) will be:

1. \(+1\) V
2. \(-1\) V
3. \(+2\) V
4. \(-2\) V