Adsorption of log(x/m) and log P was found of the following type. This is true when:-
(1) n=
(2) 1/n = 1
(3) P=0
(4) 1/n =
log(x/m) और log P का अधिशोषण निम्न प्रकार का पाया गया। यह सही है जब:-
(1) n=
(2) 1/n = 1
(3) P=0
(4) 1 / n =
Clouds, mist, fog and aerosols are colloidal solution of:
1. solid in a gas
2. gas in a solid
3. liquid in a gas
4. gas in a liquid
बादल, धुंध, कोहरे और ऐरोसॉल के कोलाइडी विलयन हैं:
(a) एक गैस में ठोस
(b) गैस एक ठोस में
(c) एक गैस में द्रव
(d) एक द्रव में गैस
In the langmuir adsorption isotherm, the postulates were:-
(A) Adsorption of a gas molecule at a particular site depends on neighboring sites.
(B) Gases undergoes adsorption behave ideally
(1) Only A is correct
(2) Only B is correct
(3) Both are correct
(4) None of these
लैंगम्यूर अधिशोषण समतापी में, अभिधारणाएँ थी: -
(a) किसी विशेष स्थल पर गैस अणु का अधिशोषण पड़ोसी स्थलों पर निर्भर करता है।
(b) गैसों का अधिशोषण आदर्शत: व्यवहार करता है
(1) केवल A सही है
(2) केवल B सही है
(3) दोनों सही हैं
(4) इनमें से कोई नहीं
Assertion: Lowering of temperature, increases the rate of physisorption.
Reason: Adsorption increases with an increase in temperature.
अभिकथन: तापमान कम होने से भौतिक अधिशोषण की दर बढ़ जाती है।
कारण: तापमान में वृद्धि के साथ अधिशोषण बढ़ता है।
Which acts as inhibitor for knocking in combustion of petrol?
1. (C2H5)4Pb
2. Ni(CO)4
3. both (a) and (b)
4. none of these
पेट्रोल के दहन में अपस्फोटन के लिए अवरोधक के रूप में कौन सा कार्य करता है?
(a) (C2H5)4Pb
(b) Ni(CO)4
(c) दोनों (a) और (b)
(d) इनमें से कोई नहीं
Which of the following reactions leads to the formation of a substance in colloidal state?
(A)
(B)
(C)
(D)
निम्नलिखित में से कौन सी अभिक्रिया कोलॉइडी अवस्था में एक पदार्थ का निर्माण करती है?
(A)
(B)
(C)
(D)
The charge on As2S3 sol is due to to the adsorbed:-
(1) H+
(2) OH-
(3) O-2
(4) S-2
As2S3 सॉल पर आवेश निम्न अधिशोषित के कारण है-
(1) H+
(2) OH-
(3) O-2
(4) S-2
Gold number:
1. may be defined as the milligram of the dry material of which the hydropholic sol is prepared and which when added to 10 mL of red gold sol, will prevent it from coagulation on the addition of 1mL of 10 percent sodium chloride solution.
2. may be defined as the milligram of the dry material of which the hydrophilic sol is prepared and which when added to 1 mL of red gold sol will prevent it from coagulation on the addition of 10 mL of 10 percent sodium chloride solution.
3. may be defined as the miligram of the dry material of which the hydrophilic sol is prepared and which when added to 1 mL of red gold sol will prevent it from coagulation on the addition of 1 mL of 1 percent sodium chloride solution
4. none of the above
स्वर्ण संख्या:
(a) को शुष्क पदार्थ के मिलीग्राम के रूप में परिभाषित किया जा सकता है, जिसमें से जलविरागी सॉल तैयार किया जाता है और जिसे 10 mL लाल स्वर्ण सॉल में मिलाया जाता है, यह 10 प्रतिशत सोडियम क्लोराइड विलयन के 1mL को मिलाने पर स्कंदन से बचाएगा।
(b) को शुष्क पदार्थ के मिलीग्राम के रूप में परिभाषित किया जा सकता है, जिसमें से जलरागी सॉल तैयार किया जाता है और जिसे 10 mL लाल स्वर्ण सॉल में मिलाया जाता है, यह 10 प्रतिशत सोडियम क्लोराइड विलयन के 10 mL को मिलाने पर स्कंदन से बचाएगा।
(c) को शुष्क पदार्थ के मिलीग्राम के रूप में परिभाषित किया जा सकता है, जिसमें से जलरागी सॉल तैयार किया जाता है और जिसे 10 mL लाल स्वर्ण सॉल में मिलाया जाता है, यह 1 प्रतिशत सोडियम क्लोराइड विलयन के 1 mL को मिलाने पर स्कंदन से बचाएगा।
(d) उपरोक्त में से कोई नहीं
Graph between log and log P is a straight line inclined at an angle - 45°. When pressure of 0.5 atm and log k = 0.699, the amount of solute adsorbed per g of adsorbent will be
(1) 1 g/g adsorbent
(2) 1.5 g/g adsorbent
(3) 2.5 g/g adsorbent
(4) 0.25 g/g adsorbent
log और log P में मध्य आरेख एक कोण -45° पर झुकी हुई एक सीधी रेखा है। जब 0.5 atm का दाब और log k = 0.699, अधिशोषक के प्रति ग्राम में अधिशोषित विलेय की मात्रा होगी:
(A) 1 g/g अधिशोषक
(B) 1.5 g/g अधिशोषक
(C) 2.5 g/g अधिशोषक
(D) 0.25 g/g अधिशोषक
Assertion : Catalyst in general, in the form of finely divided powder.
Reason : Finer is the particle of a solid, greater is its surface area.
अभिकथन: सामान्य रूप से उत्प्रेरक, सूक्ष्म विभाजित चूर्ण के रूप में होते हैं।
कारण: महीन एक ठोस का कण है, इसका पृष्ठीय क्षेत्र अधिकतम होता है।